The special screw conveyors are jointly designed and manufactured by
GN Solids Control and Italy Brand WAMGROUP, which can be widely used for the
drilling cuttings transfer, including water based cuttings, oil based drilling
cuttings, synthetic based drilling cuttings.
Features of GN new
designed screw conveyor:
(1)
Main body with reinforce support
(2)
Motor and gearbox with protection frame
(3)
Standard 12 feet each section, interchangeable,
2 or 3 or 4 sections length are available for choice
(4)
The screw material is 16Mn, with good abrasion
resistance
(5)
The screw
diameter varies from 12inch to 18inch, including 12 inch, 14 inch, 16 inch
& 18 inch
(6)
Can be installed on both the mud tank and on the
ground, horizontally installed or slanted installation with the angle smaller
than 40 degree.
(7)
VFD control panel is for option to adjust the
speed of the motor and control the flow rate
The screw conveyor is normally used in drilling
cuttings transfer system, working together with GN drilling cuttings treatment
system, it is used to feeding for the vertical cuttings dryer, collection of
cuttings from the shale shaker, mud cleaner, decanter centrifuge, and
collection of discharged solids from the vertical cuttings dryer and decanter
centrifuge, and transfer them to the cuttings box.
How to choose the correct model of screw conveyor?
Pls contact with GN solids control and provide the
info as below, we will choose the best suitable model for you.
(1)
The
distance from the feeding screw conveyor to the cuttings dryer
(2)
The
distance from the cuttings dryer to the cuttings box
(3)
The
shale shaker, desander, desilter etc solids control equipments model and qty,
we will calculate the approx length and choose the suitable sections for you
(4)
Or
you can tell us directly the length and diameter of the screw you required.